21
10. 2x16 Quick Cable Connector
PiGear Nano offers wide range of input/output and communicating interfaces, which are routed to the
green 2x16 quick cable connector.
On the back of the board, you will also see the silkscreens that mark the functionality of each pin.
Remarks: the silkscreen has the same layout as the soldering pads (instead of the holes on
the connector), please pay attention to those numbers aside.
If you want to connect a wire/cable to the connector, you can just directly plug it in to the hole with
some pressure and the wire/cable will be clamped automatically. If the wire/cable is too thin/soft, you
may want to press the orange button beside the hole so you can insert the wire/cable into the hole
easily.
The diagram bellow shows the pinout of this connector:
Summary of Contents for PiGear Nano
Page 5: ...2...
