Utopia Downton series, Installation Instructions Manual

Page: 19 / 60

WWW.UTOPIAGROUP.COM
page 19
TWIN BASE UNIT 650MM - 1200MM
Draw a line along the length of the wall for the wall brackets
(fig 2)
, the line is approx. 30mm
below worktop height, ensure that the line is drawn level.
Measure between the gables ‘Y’ in
(see fig 2)
so that the wall brackets are fitted just to the inside
of the gable
Fix the brackets to the wall by aligning the centre of the top holes in the bracket to the line X
(see fig 2)
, fix bracket with appropriate plugs and screws for your wall type (not supplied). Ensure
brackets fit just inside the gables
(see fig 3)
.
After the wall brackets are fitted to the wall:
Remove both drawer boxes before fitting the base unit to the wall.
Open and remove the main drawer by lifting the drawer up and off runners.
Push the top drawer so that it opens and lift off the runners.
Hook the base unit onto the brackets
(see fig 3)
ensuring that the arm on the unit clips behind the
anti-jump spring on the wall bracket.
To adjust the unit level and square to the wall - adjust the brackets as follows.
A - Move the cabinet up or down
B - Pull the cabinet into the wall.
Once unit has been adjusted level the basin and taps can be fitted.
Fit 2 stretcher brackets equally spaced
(see fig 4)
to the rear of the unit, level brackets with the
gable ends which will support the rear of the basin when fitted.
Re-fit drawer boxes starting with the push to open first.
Re-fit the main drawer, if drawers need adjusting in height or position - refer to page 5 for details
on how to adjust.
To square the drawer front to the base unit side:
Open the main drawer, slide the cover plate at the front of the drawer box support rail
backwards
(see fig 5)
, to revel an orange adjusting nut, turn nut either clockwise or anti-clockwise
to level the drawer front to the side gable.
If support rail needs to be removed fully, remove drawer box from unit, at the rear of the support
arm a plastic tab needs to be depressed then pull arm upwards to remove from rear panel, fold
the arm inwards across the drawer front, the arm can then be pulled from the drawer front.
For fitting and fixing a basin refer to page 40.
QUBE UNIT DRAWER BOXES.
To remove a Qube drawer box from the unit runners, pull the drawer box out and remove the
covers from each drawer side. Then by lifting the catches on each side as shown.
(See fig 6 A)
,
and release from its runner.
Please note:
When refitting ensure the runner has engaged fully at the back of the drawer box,
as this will prevent the box closing correctly.
Qube drawer box front adjustment see
(fig 6 B)
. The base drawer has a gallery rail fitted to each
side, this allows adjustment to the side gable of the unit and the back of the drawer front
(fig 7
A)
. Make adjustment by twisting the round rail clockwise or anti-clockwise, this will tilt the drawer
front back and forth to give a parallel fit to the side. Should you need to remove this rail, first
remove box from unit, at the back were the rail fits into place, press at the point
(fig 7 B).
Halo and Qube Units
Recommended
height 870mm
X
Y
A
B
Fit 2
stretcher
brackets
equally
spaced
level with
gable ends
fig 1
fig 2
fig 3
fig 4
fig 5
fig 6 fig 7
A - Lift to
remove
from drawer
runners
C - Remove the
drawer front
A
B - Raise or lower
the drawer front
B