Disposing of the CryptoServer LAN
Page 38 of 42
Figure 23: CryptoServer LAN display – status output after deletion of sensitive data
Regardless of whether you have performed an External Erase (pressing the
ERASE
push-
button) or not, the following applies:
If you remove the CryptoServer PCIe plug-in card from the CryptoServer LAN and remove
any battery from this plug-in card, the sensitive data on this plug-in card is deleted
automatically in any case after a maximum of 30 minutes.
6.2
Disposing the Batteries
In the CryptoServer LAN you will find three batteries which must be disposed of in an
environmentally friendly way.
■
The 3.6 V lithium battery made by Saft of type LS 17500
The battery is located inside the battery compartment. The battery compartment is behind
the front door of the CryptoServer LAN.
■
The 3 V lithium battery made by FDK of type CR 12600SE-T1
The battery is located on the CryptoServer plug-in card CSe- or Se-Series Gen2, which is
inside the CryptoServer LAN.
■
The 3 V lithium coin cell battery for the mainboard of the CryptoServer LAN.
This battery is located on the mainboard of the CryptoServer LAN.
Remove all batteries from the CryptoServer LAN and note the following general information
about rechargeable and non-rechargeable batteries (in accordance with the German Notice
Requirement according to §18 BattG, the Law concerning Batteries).
mode
= Maintenance Mode
state
= INITIALIZED (0x000a7f84)
temp
= 40.1 [C]
alarm
= ON
