AA
Note: Hardware shown actual size.
Machine
Screw
Qty. 2
BB
Mounting Strap
(Not shown
to size)
Qty. 1
CC
Wire Nut
Qty. 1
DD
EE
FF
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product. SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT FIXTURE SO
YOU CAN REFER TO THEM AT A LATER TIME.
the new one.
• LEDs can be damaged by electrostatic discharge (ESD) shock. Before installation, discharge yourself
by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not remove
the clear lens over the LED module.
•
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
If dimmer controls are present, remove
them and replace them with regular electrical switches. If a three-way dimmer is present, replace it with
electrician do the installation.
• This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING
CAUTION
PACKAGE CONTENTS
HARDWARE CONTENTS
PARTS
DESCRIPTION
QUANTITY
A
LED Head
2
B Sensor Arm
1
PARTS
DESCRIPTION
QUANTITY
C
Sensor Head
1
D Wall Plate
1
2
GG
Machine
Screw
Qty. 2
Long
Machine
Screw
Qty. 1
Silcone
Cap
Qty. 1
Foam Gasket
(Not shown
to size)
Qty. 1
GND
FRON
T
HH
Push-in
Connector
(Not shown
to size)
(Pre-installed
Qty. 2
A
D
B
C
