9
Operation
Panic Operation
Activating a portable panic sensor or the panel’s Call button places an emergency
call to the central station.
To activate a portable panic sensor:
❑
Wrist Panic - Press the button until its red LED blinks.
❑
Pendant Panic - Press and hold the button for 2 seconds.
To activate the panel’s Call button:
The panel’s Call button can be set up by your installer to operate in one of two ways
- a single press or two presses. The Call button may be disabled.
Single Press:
1. Press the Call button.
2. The system announces “Contacting monitoring station, please remain calm.”
Note
There may be a slight delay between the time the button is pressed and when the
panel announces it is contacting the station.
Two Presses:
1. Press the Call button once. The panel announces “Press call again for Emergency
call, or press Status to cancel.”
2. Press the Call button again to initiate an emergency call or press Status to cancel
the call.
You may also initiate an emergency call by holding down the Call button until the
system announces “Contacting monitoring station, please remain calm.”
After initiating a call the panel will...
❑
start blinking the Status LED.
❑
dial the central station
❑
announce “Contacting monitoring station, please remain calm.” This message
will be repeated every 60 seconds until contact is made with the central station.
❑
report an alarm to the central station.
❑
begin a 2-way audio session between you and the central station operator if your
system is set up for 2-way audio.
