8
No Line Seizure
This method is typically used where DSL (Digital Subscriber Line) service exists.
DSL allows multiple devices on a single phone line to be used simultaneously. Sim-
ply connecting the panel LINE jack to an available phone jack on the premises
using the phone cord is all that is required.
An in-line filter may be required to ensure panel reporting is successful.
Note
Connecting the panel to a standard phone (voice) line in this manner should be
avoided. Other devices in use at the same time the panel is using the line can pre-
vent reports from going through.
Plugging in the Power
The panel is pre-wired for power. Simply plug the transformer into an available
110VAC outlet.
Note
Make sure the outlet is not controlled by a switch or that it is not part of a ground
fault interrupt circuit (GFIC).
Powering up the System
Turn the Power switch on the back of the panel to On. The panel voice should
announce “Hello, system X is OK” and the Power LED will light up.
Adjusting the Speaker Volume
The Volume button on the front of the panel controls the volume of announcements
from the speaker and the volume during a 2-way talk session.
❑
Each time the Volume button is pressed it increases the speaker volume one level
and announces the volume level.
❑
Adjust the speaker volume the same way during a 2-way talk session. Adjusting
the volume during a 2-way talk session adjusts the volume of the central station
operator’s voice.
Note
The volume of announcements and 2-way talk sessions are independent. When a
2-way talk session ends the speaker volume returns to the level set for announce-
ments.
