11969003 Rev A
6
© 2020 UTC RETAIL
All rights reserved.
Maintenance - Base Removal/ VESA Mount
The base of the 2600 POS can be easily removed so that the 2600 can be mounted to a VESA
compatible bracket.
To remove the base, turn the unit over and place on a soft, flat surface to protect the
touchscreen. Unscrew the silver thumbscrew located above the center of the I/O panel. Slide
the base slightly rearward and lift it off the 2600.
Next remove the four base adapters using a flat-bladed screwdriver. The photo below shows
two of the adapters removed. A VESA bracket can now be mounted to the 2600 using
appropriate length metric M4-0.7 screws.
WARNING: Do not use screws that are too long or permanent damage to the 2600 may result.
Gently hand tighten the screw to be sure it is the correct length, and do not overtighten.
