2 / 4
P/N 3101591 • REV 2.0 • ISS 21MAR11
3. Remove the gasket that comes with the 449 weatherproof
box and replace it with the gasket that comes with the
WG4 speaker-strobe.
4. Place the gasket over the backplate, and then feed the
field wiring through the wire slots on the gasket and the
backplate. See Figure 5, item 3.
5. Secure the backplate to the electrical box with four
screws.
6. Connect the wiring to the terminal strip.
7. Connect the speaker to the audio NAC and the strobe to
the strobe NAC. Observe polarity. See Figure 5.
8. If temporal strobe (private mode) operation is desired, cut
jumper JP1. See Figure 5, item 5.
9. Set the speaker voltage.
The default speaker voltage is 70 V. For 25 V, reposition
the speaker voltage-setting switch S3. See Figure 5,
item 4.
10. Set the candela output.
The default candela setting is D. To select a different
candela output, align the S2 indicator to the desired
candela output. See Table 5 and Figure 5, item 1.
11. Set the wattage.
The default wattage setting is Z, corresponding to 1/4 watt.
To select a different wattage, align the S1 indicator to the
desired wattage setting. See Table 4 and Figure 5, item 2.
12. Remove the strobe protective cover. See Figure 2.
13. Position the cover over the backplate and secure with the
six cover screws.
14. Test the unit for proper operation.
Figure 1: Exploded view of the assembly
2
3
5
6
4
1
1.
Cover screws (6X)
2. Front
cover
3. Backplate
4. Optional
skirt
5. Gasket
6. Electrical
box
Figure 2: Protective Cap
1
1. Protective
cap
Figure 3: Assembled
1
2
3
4
1. Optional
skirt
2. Backplate
3. Front
cover
4.
Cover screws (6X)
Figure 4: Mounting positions
