I don‟t have Channel and Volume buttons on my
device‟s Remote Control page.
Some Remote Control options use
BX7000
‟s buttons
such as “CH +/-”, “VOL +/-”, “Mute”, “Cursor Control”,
“Menu”, and “Exit”. These buttons perform exactly the
same as on-touch Remote Control buttons in Remote
Control mode.
Macro options don‟t work.
If you experience a problem in using macro options,
please check the followings;
①
Make sure to aim
BX7000
‟s IR transmitter toward the
selected device. Considering that you are using
macro options to control multiple devices at the same
time, all the target devices should be placed within
BX7000
‟s IR signal area which is quite wide: 100˚
from left to right, and 80˚ from top to bottom.
②
Check the battery‟s remaining capacity. If the battery
is ran out,
BX7000
may not be able to transmit IR
signals to the device.
③
Check the target device‟s status. For instance, if
BX7000
is about to turn on the device, but the device
already has been turned on, it may cause a malfunction of
BX7000
, and
BX7000
might turn off the device as the
result.
④
When you command macro actions to one device,
check “Delay” of the actions.
⑤
Open the “Edit Macro Action” menu, test the macro
button, and reconfigure the macro action that does not
work properly.
A timer doesn‟t work.
If you experience a problem in activating a timer, please
check the followings;
①
Aim
BX7000
‟s IR transmitter toward a device which will
be activated by the timer. If the timer is configured to
control multiple devices at the same time, all the all the
target devices should be placed within
BX7000
‟s IR
signal area which is quite wide: 100˚ from left to right, and
80˚ from top to bottom. Since the timer is going to control
the devices instead of you hand-holding
BX7000
and
controlling them, you have to place
BX7000
in a place
where it can control the devices without causing a
malfunction.
②
Check the battery‟s remaining capacity. If the battery is
ran out,
BX7000
may not be able to transmit IR signals to
the device.
③
Check the target device‟s status. For instance, if
BX7000
is about to turn on the device, but the device already has
been turned on, it may cause a malfunction of
BX7000
,
and
BX7000
might turn off the device as the result.
④
If the timer is configured to command multiple actions to
one device, check “Delay” of the actions.
⑤
If the timer was not activated at the set time, check
BX7000
‟s clock, and see if the clock indicates the correct
time. Make sure that the timer‟s activation time is affected
by the clock. For next, please check the timer‟s registered
activation time.
⑥
If the timer‟s action does not work properly, test the action
on the “Timer Action List”, and reconfigure the action.
61
