Utah Medical Products FINESSE +, Service Manual

Page: 35 / 54

Service Manual
31
Test Procedures
This checklist is intended to provide information for the preventive maintenance (PM) of the
Electrosurgical Generator and Smoke Evacuation Systems. It is intended for use by
technical personnel who have experience with electrosurgical generator operation and
maintenance, and who possess the test equipment and tools necessary to obtain the requested
data. This document may not reference all tests necessary to demonstrate compliance to all
regulations, nor should all tests listed be considered necessary for the safe use of the .
Technical personnel should consult local regulations and industry recommendations to develop
their own protocol for inspection and PM of the .
Required Equipment and Tools
• Electrosurgical analyzer and leads
• Electrical safety analyzer, with patient lead connections
• Two-button electrosurgical switchpen and/or two-pedal footswitch
• SSE-500 Internal Smoke Evacuation Filter
Mechanical Inspection and Service

Pass Verify front panel controls, switches, and dispersive pad receptacle/pins are not
damaged.
 Pass Verify switchpen receptacles firmly hold switchpen.

Pass Knobs and color coded knob caps are securely attached.
 Pass Verify power cord and its rear panel receptacle are not damaged.

Pass Verify footswitch cord (if present) and its rear panel receptacle are not damaged.

Done Replace Internal Smoke Evacuation Filter
Performance Inspection

Pass Green LED in main power switch lights when switch is toggled to the " " position.

Pass One and only one cut mode indicator (“C”, “1”, “2”, or “3”) is illuminated..
 Pass For all four cut/blend modes, the cut mode waveform selector knob adjusts so that light
indicator for each mode illuminates when knob’s index pointer corresponds to the
correct indicator light.
Verify power displays can be adjusted through the full output range
 Pass Cut: 05-99  Pass Coag: 05-75
Press cut button on switchpen (repeat with cut pedal on footswitch, if available), and verify:

Pass Yellow cut activity indicator lights and cut mode tone is audible
 Pass Smoke evacuation motor activates, and remains running 5 seconds after deactivation
Press coag button on switchpen (repeat with coag pedal on footswitch, if available), and verify:

Pass Blue coag activity indicator lights and coag mode tone is audible

Pass Smoke evacuation motor activates, and remains running 5 seconds after deactivation