• Plug the grill into a three-wire, grounded wall outlet.
• Press the power button to turn the unit on. DO NOT
TOUCH THE AUGER OR THE IGNITOR! Open the
hopper lid and check to see that the auger is turning
freely - approximately 2 rpm. LOOK TO SEE THAT THE
AUGER IS TURNING. DO NOT TOUCH.
• Place your fingers over the burn pot and feel the air
movement from the combustion blower. Ignitor will
glow within 1 minute.
• Press the power button to turn the unit off.
• Clean the small rack, large rack, small shield, large
shield, and griddle with soap and water, then rinse.
Allow the components to dry before continuing the
assembly.
DO NOT TOUCH THE IGNITOR OR THE
AUGER.
GRILL GRATES, DRIP PAN, & FLAME PLATE
INSTALLATION
Insert the main shield into the grill. Ensure the slot in the
left side of the main shield hooks onto the corresponding
tab The right side of the main shield will rest on the
grease trap.
Place the small shield onto the main shield.
IMPORTANT:
KEEP THE SMALL SHIELD IN THE CLOSED
POSITION AT ALL TIMES. WHEN THE SMALL
SHIELD IS IN THE OPENED POSITION THE FLAME
WILL HAVE DIRECT CONTACT WITH THE FOOD.
GRILLING GRATES AND GRIDDLE
The large and small racks can be installed in two different
ways. The first is to stack the small rack on top of the
large rack.
The second is to put the large rack into position and
attach the small rack to the side of the grill as shown. The
small rack can be attached on left or right side of the grill.
ASSEMBLY INSTRUCTIONS
6
© 2021 United States Stove Company
