DAX-‐16 Installation & Operation Manual
Rev 1.4
17
22.
Click the Save Settings buttons to save all the DAX-‐16 settings. These are saved to an external
flash memory chip AND to the SD card.
23.
Click the Configuration Page link to go back to the configuration page (shown in figure 4).
24.
Click the Config Flash link to view the data saved to the configuration page (a portion is shown in
figure 8).
Figure 8 -‐ DAX-‐16 configuration flash page.
25.
Click the browser back button to get back to the configuration page.
26.
Click the SD card link to view the configuration saved to the SD card. If this page says “Could not
initialize SD card” or some other error message, ensure an SD card is in place and that its write
protect is not enabled (SD cards are write protected or locked when the plastic slider on the left
side of the card is slid towards the middle of the card). Figure 9 shows a portion of a typical SD
card page.
27.
If bypass audio is to be used, configure the passive crossover.
a.
Ensure the DAX-‐16 bypass power supply is powering the DAX-‐16 (front panel Bypass
Power LED lit).
b.
Turn off the DAX-‐16 main power. The Bypass Power LED should flash.
c.
Set the bypass crossover switches as per the table on page 7.
d.
Put the sound processor in bypass (generally, turn it off).
e.
Apply pink noise to the processor (typically an external pink noise source on NS).
