YOUR SOURCE FOR LAMINATION • USI
17
COOLING FANS
Every MRL Roll Laminator/Mounter is factory equipped
with cooling fans.
For the best laminating results the cooling fans should be
used. The control for the cooling fans is located on the right
control console.
The fan control has three positions: Off, On and Auto.
When the auto position is selected, the fans turn
on and off automatically with the drive motor.
To conveniently trim your laminated items, your laminator is
equipped with in line slitters. The round knob on the left side
of the laminator raises and lowers the slitters.
•
To adjust where the slitters cut, first remove the
laminating film from the rollers.
•
Next raise the slitters to their operating position by
rotating the control knob.
•
Using an Allen wrench, loosen the locking screw on
the slitter blocks. Slide the slitter blocks to the
desired location.
•
Tighten the locking screws.
•
Lower the slitters to their retracted position and
re-thread the laminating film. Now the slitters can be
raised and lowered to use.
Additional slitters can be added.
Photo 15A.
Cooling fans plug.
Photo 15C.
Using an Allen wrench, loosen the
locking screw on the slitter block.
Photo 15D.
Slide slitter block to desired location.
Photo 15E.
Exiting lamination trimmed by slitters.
Photo 15B
Cooling fans.
IN LINE SLITTERS