Installation
11/20
Fl Remote Set
13
5.7
Deleting the programming
Press the "Learn" button (11) 8 times briefly.
The LED above the "Learn" button flashes each time.
After pressing 8 times, the LED flashes briefly 3 times.
All codes stored in the radio receiver are now deleted.
5.8
Functional test
Start Fl and wait until the flow duration indicator stops
flashing.
For testing, bridge the sensor surfaces (13) of each water sensor one
after the other at the final operating location by placing it on a damp
cloth.
The Fl should then shut off after approx. 5 seconds.
Reset the Fl.
Now repeat this test with all water sensors.
To test, press the "lock" button 15 on the remote control (3) for about
3 seconds.
The Fl will lock after approx. 5 seconds.
Now press the button 16 "reset" on the remote control for about 3
seconds.
The Fl is reset.
By changing the position of the throwing antenna (16) the
radio transmission can be optimized if necessary.
