1
INTRODUCTION
This operator is intended to be installed on vehicular Class I or Class II gates as defined by
UL 325. Maximum gate load not to exceed 250 pounds.
PLEASE READ THIS ENTIRE MANUAL CAREFULLY PRIOR TO INSTALLATION.
In doing so, along with performance of the installation in step-by-step order, you
will achieve optimal results. We strongly recommend that all installation and
service personnel pay particularly close attention to the safety systems section of
this manual and UL325. In addition to the current sense feature that is provided,
other safety devices are necessary to make each particular installation as safe as
possible to reduce the risk of personal injury and/or property damage. A trained
and authorized service technician or the
factory should be consulted
for
assistance.
Cautions - Very Important
Do not attempt to enter the gate area while the gate is moving. Wait until
the gate comes to a complete stop.
Operate the gate only when it is fully visible, free of persons or obstructions,
and properly adjusted.
Do not allow children to play in the area of the gate. Do not allow anyone
to ride on the gate.
Do not allow children to play with the remote control or any other
activation device.
Do not attempt to "beat the gate" while the gate is opening or closing.
This is extremely dangerous.
Test the current sense feature and all safety devices regularly to insure
correct operation.
Study the entire Safety Section on pages 17-21 paying particularly close attention
to the Entrapment zones, and be aware of these areas not only during use but also
during any adjustments to the unit.
Other Safety Standards
All control stations should be located at least 6 feet from any moving part
of the gate or operator.
Do not ever install any control device where a user will be tempted to reach
through the gate or fence to activate a gate.
© USAutomatic, Inc., 2001 rev.U
All rights reserved. No part of this may be reproduced by any means
without the expressed written consent of the publisher.
Summary of Contents for STAR I
Page 2: ......
