pre-wired CD changer location.
top view of the male plug female pin at the vehicle’s
manual.
If your iPod has more than 4 Playlists, see Playlist Naming in Section 5 of this
keypad. Steering wheel control and track up and down buttons on radio will also work.
If you prefer the interface to be always in Direct Mode, simply set the DIP switches
as follow. Then, access and control everything on your iPod directly from iPod
3-2 Always Direct Mode + Direct Mode Only Configuration
DIP # 2
DIP # 3
DIP # 4
OFF
ON
ON
Step 1- Set DIP switches according to instructions in Section 3.
Step 2- Must remove or eject all CDs from radio.
Step 3- Locate the factory CD changer cable in your vehicle. (See appendix A for
Step 4- Unplug the cables from the CD changer and / or satellite receiver if such
Step 5- Verify the BROWN wire position on the factory CD changer cable as follow:
cable location references).
options are installed in your car.
Step 6- Connect the 3-pin connector on factory CD changer cable to the 3-pin
Step 7-
For PA12-BMW model:
connect the 6-pin male connector on factory
female connector on CDL-BMW cable.
CD changer cable to the 6-pin female connector
Note: If a 3-pin connector without a brown wire on it is plugged to this
iPod interface, sever electrical power short circuit will happen!!!!!
SECTION 4. CABLE CONNECTION
(
Reference Fig. 1 & Fig. 2
)
on CDL-BMW cable.
For PA12-BMWdsp model:
connect the factory digital audio cable to
Make sure the plug’s #3 wire is BROWN
3 BROWN
2 Red / white
1 White or white / yellow
pin / wire # Color
CDL-BMD cable.
