Page 9
OPERATING INSTRUCTIONS
Power On
• Press the “
ON/OFF” button for 20 seconds to power the scale ON.
The scale will automatically flash the voltage and auto-check. It performs a sequential
countdown from 0 to 9 before entering the weighing mode. The Scale also tares out anything
on it before powering on.
Zero function
This function is applied when the scale is empty. It cannot be used if material build up places
the scale at gross zero.
• To reset your scale display to 0, press the
ZERO function.
You are allowed to zero out any number within your set selection, depending on the setting
of your manual zero range parameter. After that, you will receive an error and will have to
tare out the weight.
Unit Selection
• Use the
UNITS button to toggle measurement units between kilogram (kg), grams (g),
pounds (lb), ounces (oz).
Tare Function
The Tare function enables you see the current change in weight, as against the entire weight
on the scale. To view the changes,
• Add the pallet to the scale
• Press the TARE button when the indicator is in gross mode. When you do that, the
current weight on the scale will be tared and the scale will enter the net mode.
• Add your product to the scale to weigh without the pallet’s weight.
• If you want to exit net mode, press the TARE button again to enter the gross mode.
When you exit net mode, the total weight of the pallet and product will be shown on the
scale. If however, you remove the pallet, the scale will show the minus weight of the pallet.
For a pre-set tare weight,
• Press and hold the TARE key for 2 seconds
• Input the tare weight using the arrow keys
• Press print key to confirm
Counting Function
If you want to count a high volume of identical parts, then the counting function is the option.
You can either set a sample on the scale, and add to it or take away from the sample to count
the number of objects on the scale. When you enter weighing mode,
• Place a sample on the scale.
• Press the
COUNT button to enter the counting mode.
• In counting mode, PCS will show on the scale.
• The sample number will be displayed on the scale, which can be changed using the
arrow buttons (up and down arrow buttons).
• PCS precedes the sample number on display.
• Press the
PRINT button to confirm your sample number
