13
Fusion Backwashing Filter Tank Installation Instructions
WATER PRESSURE:
A minimum of 30 pounds of water pressure is required for the backwashing valve to
operate effectively.
ELECTRICAL FACILITIES:
An uninterrupted alternating current (A/C) supply is required. Note: Other volt-
ages are available. Please make sure your voltage supply is compatible with your unit before installation.
EXISTING PLUMBING:
Condition of existing plumbing should be free from lime and iron buildup. Piping
that is built up heavily with lime and/or iron should be replaced.
LOCATION OF FUSION TANK AND DRAIN:
The tank should be located close to a drain to prevent air
breaks and back flow.
CAUTION:
Water pressure is not to exceed 80 psi, water temperature is not to exceed 110°F (43°C), and
the unit cannot be subjected to freezing conditions.
Media Installation
1) Remove the tank from carton.
2) Verify the riser tube is secured in the bottom center of the tank. A flashlight may be
necessary.
Carbon Filter Installation
Summary of Contents for Matrixx 150-FLCS Series
Page 10: ...10 Retention Tank Installation ...
Page 29: ...29 Flow Schematic ...
