8
Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792
System Installation
5.
Mount the RO system on the wall using the proper wall fasteners. It is recommended
that the system is mounted using wall studs. Sometimes a backing board is needed
to secure the studs and the RO system.
BE SURE
to mount the system level.
6.
Install the fittings on the storage tank and quantum disinfection filter.
NOTE:
The system will be heavier when it fills with water.
1.
Check the bladder pressure in the storage tank and BE SURE it is between 8-10 PSI.
Place the tank as close to the RO system as possible.
2.
Attach a 3/8” tube to the carbon filter “IN” port.
3.
Attach a 3/8” tube from the carbon filter “OUT” port to the feed water tube on the RO
system
4.
Run the concentrate 3/8” tube from the RO system to a sanitary drain.
5.
The permeate/product tubing from the RO system should be connected to the quan-
tum disinfection filter inlet.
6.
The quantum disinfection filter inlet can be identified by looking at the flow arrow on
the side of the filter. The inlet is the base of the arrow. The outlet is the point of the
arrow.
7.
Run a 3/8” tube from the quantum disinfection filter outlet to the storage tank tee fit-
ting.
8.
From the storage tank a pipe or tube can be ran to all points of use requiring the fil-
tered water.
System Connections
