CE Declaration of Conformity
We, U.S. Robotics Corporation of 935 National Parkway, Schaumburg, Illinois,
60173-5157,USA, declare under our sole responsibility that the U.S. Robotics
802.11g Wireless USB Adapter, to which this declaration relates is in conformity with
the following standards and/or other normative documents:
EN300 328-2
EN301 489-1
EN301 489-17
EN50371
EN60950
This equipment is in compliance with the European recommendation 1999/519/ECC,
governing the exposure to the electromagnetic radiation.
We, U.S. Robotics Corporation, hereby declare that this product is in compliance
with the essential requirements and other relevant provisions of Directive 1999/5/EC.
This product can be used in the following countries:
Germany, Austria, Belgium, Switzerland, Netherlands, Luxembourg, Italy, France,
UK, Ireland, Spain, Portugal, Sweden, Norway, Denmark, Finland, Iceland, and
Greece
Regarding IEEE 802.11b we currently have the following information about
restrictions in the R&TTE countries:
EU Health Protection
This device complies with the European requirements governing exposure to
electromagnetic radiation. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body. This wireless device is
a transmitter/receiver and has been designed and manufactured to comply with the
exposure limits recommended by the Council of the European Union and the
International Commission on Non-Ionizing Radiation Protection (ICNIRP, 1999) for
the entire population. The exposure standard for portable equipment uses the
"Specific Absorption Rate" as unit of measure. The maximum SAR value of this
wireless device measured in the conformity test is x.xxx W/kg.
EU Detachable Antenna Information
This USR wireless device has been designed to operate with the antenna included in
this package only. Together this device and antenna combination has been tested
and approved by a European Agency conforming with the European R&TTE
directive 1999/5/EC to meet the radiated power level requirement of 100mW e.i.r.p.
Replacement of this antenna must only done with an authorized USR component
that has been designed and tested with the unit to the requirements of directive
1999/5/EC. Please refer to the USR web site to get product antenna ordering
information.
Go to
www.usr.com
to see the most recent channel restriction information.
Manufacturer's Disclaimer Statement
The information in this document is subject to change without notice and does not
represent a commitment on the part of the vendor. No warranty or representation,
either expressed or implied, is made with respect to the quality, accuracy or fitness
for any particular purpose of this document. The manufacturer reserves the right to
make changes to the content of this document and/or the products associated with it
at any time without obligation to notify any person or organisation of such changes.
In no event will the manufacturer be liable for direct, indirect, special, incidental or
consequential damages arising out of the use or inability to use this product or
Country
Frequency Band
Output Power
France
2446.5-2483.5 MHz
10 mW EIRP outdoor
Operating Channels
:
z
IEEE 802.11b compliant
z
11 channels (US, Canada)
z
13 channels (ETSI) 14 channels (Japan)
U.S.Robotics declares that USR5420 ( FCC ID: MXF-U921201G ) is limited in CH1~CH11 by specified firmware controlled in U.S.A.
