Urrea EA1007A, User Manual And Warranty

Page: 13 / 16

13
E N G L I S H •
User's Manual
When making masonry cuts, always cut with a
cutting guide. The cut direction is very impor-
tant on this kind of operation. The tool must
work in the opposite side to the rotation direc-
tion of the cutting disc.
CAUTION: It will generate sparks when you
grinded on metal. Be careful that it doesn’t
make contact with combustible materials
MAINTENANCE
WARNING: It’s recommended that all repa-
rations been made by an authorized service
center.
GENERAL MAINTENANCE
Before each use inspect the tool, the switch and
the wire to check any damage. Verify that don’t
have damaged, missing or worn parts. Check
if there are lost screws, misalignment or loose
moving parts or any other condition that may
affect the operation.
If an abnormal vibration or noise occurs, imme-
diately turn off the machine and solve this issue
before to try use again.
CARBON BRUSHES
The carbon brushes and the collets must be
examined frequently. A good contact result the
tool to be strong. When the spark around the
collector becomes largest the carbon brushes
should be changed.
CLEANING
WARNING: before to clean or realize any kind
of maintenance, the tool must be unplugged of
the power source. The most effective cleaning
method could be flow the tool with dry com-
pressed air. Always use goggles when perform
this activity. Keep the handle clean, dry and oil
free. Use only a gently soap and a wet wiper
to clean the tool. Many cleaning products has
chemical which can seriously damage the plastic
and other isolated parts.
The ventilation slots must be kept clean. Don’t
try clean it introducing sharp objects trough
ventilation slots.
CAUTION: don’t use chemical agents as pe-
troleum, solvents or similar products to clean
the tool.
WARNING: use only accessories that are
recommended by the manufacturer for your
model. Accessories that may be suitable for one
tool may become hazardous when used with
another tool.
WARNING: maintain tools with care. Keep
cutting tools sharp and clean.
Properly maintained tools, with sharp cutting
edges, are less likely to bind and are easier to
control.
WARNING: check extension cords before
each use. If damaged, replace immediately. Nev-
er use tool with a damaged cord.
TROUBLESHOOTING
MOTOR DOES NOT START
Tools is not plugged in: check that all cords are
plugged in.
Fuse: check the time-delayed fuse or circuit
breaker.
TOOL VIBRATES OR SHAKES
Damaged disc: replace disc
Loose disc: tighten arbor bolt.
If the machine presents other problems contact
your closest service center for maintenance.