10
DS1139-004
After one second, the multicolour LED (6) will blink red for the number of times the button
was
pressed in sign of con
fi
rmation and then will start blinking with yellow light again.
3. press the button to scroll the 5 available ring tones; the multicolour LED (6) blinks red to con
fi
rm the
selection;
4. after having made the selection, the user can:
select a different call source for which to change the call tone, by repeating the operation from step 2,
close programming mode by holding button
pressed for longer than 5 seconds; in all cases, after
10 minutes the device exits programming state and the changed parameters are saved (two long
beeps are heard).
2.8. ADJUSTING THE CALL VOLUME
Proceed as follows to adjust the call volume (from calling station and to
fl
oor):
1. enter programming mode by holding button
pressed for longer than 5 seconds; the yellow LED will
blink slowly to indicate that programming mode has been selected and the door phone will beep 3
times;
2. pressing the button
will generate a con
fi
rmation beep at the new set call volume (the volume changes
according to the sequence LOW, HIGH, MUTE);
3. close programming mode by holding button
pressed for longer than 5 seconds; in all cases, after 10
minutes the device exits programming state and the changed parameters are saved (two long beeps are
heard).
2.9. PANIC
ALARM
The “Panic Alarm” signal can only be activated if a button was connected to the “PANIC” terminals.
When the button is pressed, the door phone emits the
fl
oor call (even if the door phone was in
mute mode).
IMPORTANT
The following requirements are needed for the panic alarm function:
the system has a switchboard
the system was con
fi
gured appropriately (for more information see the IPerVoice handbook on the
www.urmet.com
website);
the switchboard is manned;
the switchboard operator is instructed on what to do if a panic alarm is received.
2.10. AUTOMATIC DOOR OPENER
To activate the automatic door opener service:
1. enter programming mode by holding button
pressed for longer than 5 seconds; the yellow LED will
blink slowly to indicate that programming mode has been selected and the door phone will beep 3
times;
2. press the button
:
• if the function was active, the multicolour LED (6) blinks
(4)
with green light;
• if the function was deactivated, the multicolour LED (6) is off;
3. close programming mode by holding button
pressed for longer than 5 seconds; in all cases, after 10
minutes the device exits programming state and the changed parameters are saved (two long beeps are
heard).
(4)
Only after having exited programming mode.
–
–
•
•
•
•
