4
−−−−
sec.2b
K-STEEL CALL MODULE
BIBUS 2
nd
Ed. VOP - Technical Manual
Ref.
072/
4
K-STEEL CALLING MODULE WITH REPERT
ORY
DOOR OPENER CODES
Press the
button before entering each door opener code.
Symbol “
∗
” will appear on the display when entering the code for each
button.
The module will open the door if the code is valid. A warning will be
output if the code is not valid.
The sequence is the same for “Generic” and “Personal” door opener
codes: press
followed by the door opener code. The following will
appear on the display:
The lock will be operated and the following message will appear if the
code is correct:
GENERIC DOOR OPENER CODES
The generic door opener codes can be used by residents and other
authorised persons to release the lock.
The calling module is dimensioned to contain
up to eight generic
door opener codes
for operating the electrical lock. The codes have
four digits (no letter permitted).
The eight generic door opener codes must be validated according
to the time of day. The codes will operate the door lock only if the
contact of the clock external to the module is open. Otherwise, the
eight generic codes cannot be used to open the lock.
PERSONAL DOOR OPENER CODES
A door opener code can be associated to each name. Other 250 door
opener codes can be thus programmed in addition to the generic
codes. These 250 door opener codes are not concerned by the clock
contact.
BUSY FUNCTION
This function is only required in systems with more than one calling
device. This function is used to ensure that a conversation lasts
sufficiently long following a call. The following message indicates
busy status:
The keyboard is disabled during this time.
Two cases can occur:
BUSY TIME BEFORE THE CALL USER GOES ON-HOOK
This is the maximum time for the user to lift the handset or open the
door without loosing the call after the ring.
BUSY TIME AFTER USER GOES ON-HOOK
This is the minimum guaranteed conversation time from when the
handset is picked up.
CALLS TO USERS BY SELECTING THE CODE
Dial the code of the user to be called (numeric or alphanumeric with
optional keyboard). The following will appear on the display:
Enter the code and press the
to call the selected user.
The apartment door phone will ring for approximately 3 seconds. Hold
pressed to send up to three consecutive calls.
Press to interrupt the call to the previously selected user.
The following message will appear on the display if the user picks up
the handset:
Press to end the conversation with the user.
The following message will appear if the user does not answer within
the programmed pick-up time:
DIRECT CALL TO CONCIERGE SWITCHBOARD
Press
on a calling module installed in a system with concierge
switchboard to call it directly. This is only possible when the concierge
switchboard is in day mode, i.e. when the concierge service is
operative and the function has been activated (see “Programming”).
The following message will appear on the display:
The following will appear on the display if
is pressed and either
the concierge switchboard is in night mode or the function has not be
activated (see “Programming”).
K-STEEL CALLING MODULE WITH REPERTORY Ref. 072/4
OPERATION
CALL TO:
n°1001
CALL
IN COURSE
TALK
PLEASE
User
does not reply
Select NAME
with
↑
or
↓
CALL TO:
Switchboard
CODE NOT
VALID
LOCK REL. CODE
****
Go in
Please
LINE BUSY
Please wait
