6
DS1060-162A
ENGLISH
WARNING!
For a functioning of the device it is strictly necessary that the firmware version of the Ipercom
system is 2.1.0 or higher
. The firmware version update of the Ipercom system is available on the Urmet
website in the Download/Software section.
1. DESCRIPTION
The device Ref. 1060/23 is an Elekta Steel vandal-proof call module for Ipercom system.
The main features are:
• Signal management using 3.5” graphic colour display and evolved graphic user interface (GUI).
• Simultaneous lock with pulse capacitance discharge (SE+; SE-) and no-voltage contact relay (C-NC-
NO) operation.
• Garage gate lock low current operation (SE2).
•
Hall button input.
•
Door sensor input.
• Audio repeat device control for use with hearing aid.
• LAN connection with RJ45 connector and Power Over Ethernet (POE).
• Set-up by means of 2 terminals for powering via local power supply Ref. 1039/20.
• Mifare Plus proximity key reader.
• Infrared proximity sensor for user detection.
• CMOS sensor colour camera with wide-angle lens.
• Alphanumeric keypad with 18 buttons, three of which multifunctional.
2. INSTALLATION
• Arrange the duct so that it ends in correspondence with the lower hole of the flush-mounting box.
• Remove the lower cap from the wire hole (1).
• Apply adhesive labels on the holes for the screws of the frame (2).
• Install flush-mounting box at indicated height (3).
• Fix the magnet (tamper) at the indicated height with the two-sided adhesive tape included (4).
• Fix the frame to the flush-mounting body (5).
• Make the electric connections.
• Fix the calling module to the frame (5).
ALTO
TOP
HAUT
A
ALTO
TOP
HAUT
B
ALTO
TOP
HAUT
118 mm
1,55 ÷ 1,60 m
298 mm
1
2
3