DS1092-229
13
5.4.3
FOCUSING FUNCTIONS
The camera focus may be adjusted manually using the
FOCUS +
and
FOCUS -
controls.
As the autofocus function is always on, a manual setting made using
FOCUS +
and
FOCUS -
will be kept only until a
pan, tilt or zoom command is used. In this case, autofocus will adjust focus automatically again.
Refer to the specific section for additional details on focusing and on the various options.
IMPORTANT NOTE
The autofocus function cannot work correctly in the following cases:
The object to be focused on it not in the middle of the image.
There are far and near object in the frame.
Bright light is shining on the subject.
The subject is behind a glass pane covered in drops or dust.
The subject is moving very quickly.
The subject is not well lit.
The subject is too big.
5.4.4
IRIS OPENING FUNCTIONS
The iris cannot be manually open in the Easy Dome 1092/679.
5.4.5
PRESET POSITIONS PROGRAM AND RECALLING
The Easy Dome 20X camera can store up to 128 panning, tilting and zooming configurations (called preset positions)
which can be recalled at any time.
Presets from 1 to 64 can be managed by the OSD menu and by direct commands on the keyboards; Presets from 192 to
225 can be managed only by direct commands on the keyboards
The manual focusing and iris opening settings cannot be stored.
The following examples show how to program the free presets and recall them:
Example: programming preset number 32
1. Position the camera in a certain pan, tilt and zoom configuration.
2. Enter the command
32+PRESET (1092/621)or 32+ENTER (1092/693).
3. The setting is saved and the message “
Stored
” appears.
From this moment onwards, simply enter the command
32+SHOT (1092/621)or
SHOT + 32 + ENTER
(1092/693)
to move the camera to the preset position.
Important note:
The saved value will be written over if the setting is reprogrammed.
The presettings are saved in a permanent memory area of the camera where they are maintained also when power is
disconnected. However, restoring default settings will delete all preset values.
Caution. The presettings store the coordinates according to an angular reference system. Therefore, the reference
system zero point may become misaligned with the camera mechanics after prolonged use of the tilting and panning
functions. Minor inaccuracies in preset positions may occur. In this case, calibrate the angular coordinate system using
the {dome reset} command. This calibration is automatically run when the camera is switched on.
