DS 1092-171
31
Option
Value
Explanation
BURST
ON
÷
OFF
When active, colour burst is applied also with the camera
in black and white mode.
CNTL SIGNAL
INT ÷ EXT1 ÷
EXT2
The control type used to select Day/Night mode.
EXT controls light sensors (CDS) in the camera to operate
the Day/Night mode selection.
In INT mode the switch is determined according to the
light on the sensor and the set parameters (see below)
instead of the CDS signal.
RECOMMENDED SETTING: Ext1
DO NOT USE Ext2 for this model.
DELAY CNT
0 ÷ 255
This establishes the interval of time for the Day to Night
and from the Night to Day switch.
DAY NIGHT
0 ÷ 255
This defines the Day to Night switching level.
NIGHT DAY
0 ÷ 255
This defines the Night to Day switching level.
IR OPTIMIZATION SUBMENU
Option
Value
Explanation
MODE
AUTO ÷ CENTER
This configures the IR optimisation area.
IR AREA
Top ÷ Bottom ÷
Left ÷ Right ÷
Weight
Select CENTER in the MODE option to define an area.
LEVEL
00 ÷ 12
IR optimisation intensity level.
COLOR NIGHT
ON
÷
OFF
This mode is used to take colour pictures in poor lighting
conditions also with infrared lighting. This camera can
reproduce colours when infrared lighting is activate by
managing the signal so as to separate the infrared
components of the image and extract the original colours
of the subject.
It is important to note that natural colours will not always
be reproduced in this mode.
Colour gain settings are: low, medium, high.
IR SHADE COMP
ONO
÷
OFF
This is used to compensate a brightness difference in the
corners of the picture caused by IR light shadows. Do not
change the set parameters
D/N AUTO SETUP
BURST
ON
CNTL SIGNAL
INT
DELAY CNT
■█■■■■■■■
001
DAY NIGHT
■■■█■■■■■
060
NIGHT DAY
■■■■█■■■■
084
