DIGITALIZER REF. 1052/7R
INSTALLATION
7
INSTALLATION
This device is designed for inside use.
Digitalizer can be mounted on DIN rail or fastened to the surface
with two screws or bolts with minimum dimensions of
φ
4/50mm.
Mounting of digitalizer is shown on figures 1- 3. To mount digitalizer
on a DIN rail it is required to pull blocking cotter (use flat
screwdriver), insert digitalizer on DIN rail, and push the cotter.
Fig.. 1 Blocking cotter relasing.
Fig. 2 Mounting of digitalizer on DIN rail.
Fig. 3 Pushing the cotter.
DEVICES LOCATION
All devices should be installed in dry and airy places. It is
recommended to install these devices in special boxes designed for
this purpose.
Equipment should be separated from near electric, phone, antenna
lines, etc
WIRES
To the single connector can be attached a wire with a maximum
diameter of 1,5 mm
2
. For connections, use cables with sufficient
cross section given in the tables below. Do not twist the wires in
order to increase their cross-section.
Using a link cable, please note that the unisolated end of the wire is
properly twisted and will not cause short circuits between adjacent
terminals.
If stiff cables are used please note that device is mounted properly
that wires will not cause the detachment of device or damage of
terminals.
All cables should be tied together and properly labeled
ELECTRICAL CONNECTIONS
All the electrical connections must be made by the man with basic
knowledge of electrical engineering.
All connections must be made in accordance to attached schemes
and with disconnected power supply.
