ureach MTS-SAS Series, User Manual

Page: 24 / 67

24
❸ Copy and Setting
Copies HPA setting and data from source device to target.
Scroll to select "6.9.9 HPA Copy Modes >> Copy and Setting”, then press "OK" to save this
setting.
6.9.10 Clear HPA at Erase
Sets to clear HPA setting during erase.
Scroll to select "6.9.10 Clear HPA at Erase”, then press "OK" to save this setting.
❶ Clear HPA Setting
Clears HPA setting and data during erase.
Scroll to select "6.9.10 Clear HPA at Erase >> Clear HPA Setting”, then press "OK" to save this
setting.
❷ Keep HPA Setting
Keeps original HPA setting and data during erase.
Scroll to select "6.9.10 Clear HPA at Erase >> Keep HPA Setting”, then press "OK" to save this
setting.
6.9.11 Mark After Erase
Creates watermark on the device(s) after erase job is completed. This watermark will show
when executing “ 5.1 Show Disk Info.”
6.9.12 Transfer Rate
Allows user to select the transfer rate.
Scroll to select "6.9.12 Transfer Rate”, then press "OK". Select the desired transfer mode
from UDMA2 to 7. The default is UDMA7.
6.9.13 Stop Motor Time
Sets device power down buffer time when tasks are completed.
Scroll to select "6.9.13 Stop Motor Time”, then press "OK" to set buffer time from 1 to 20
seconds. The default is 5 seconds.
Caution
HPA function “Copy and Setting” may change the original parameter of target
devices. To reset it, user must set “6.9.10 Clear HPA at Erase >> Clear HPA
Setting” and then execute “4. Erase.”