29
Note
l
Loop 0 is equal to Loop 99999
l
The duplicator will abide by the last setting picked if users chose both
“Burn Time” and “Loop Count.”
8.5 Set Test Range
Sets the flash media test range. The range can be set from 1%
to 100%.
8.6 Set Bad Limit
Sets the error tolerance. Tolerance can be set from 1-10000
bad sectors. The system will count per whole test, not per loop.
8.7 Set Data Pattern
Sets the Burn-In test writing value. There are two data patterns:
l
Auto Pattern: The default value will be used during burn-in test. Default value is
random repetition of FF and 00.
l
User Defined: Users can manually indicate which value to use during burn-in test. The
setting is only 1 byte.
8.8 Compare Count Per Loop
Sets the compare count in each loop during Auto Data burn-in test. The default setting is
one compare (reading) test per loop.
Note
“Compare Count Per Loop” setting is only available in [8.2 Burn-In (Auto
Data)].
8.9 Power Off Between Loop
Sets the power off time range between loops. This can be set from 0 to 15 seconds.
8.10 Compare Count Per Copy
Note
“Test Range” setting is only available in [8.2 Burn-In (Auto Data)].
Note
“Data Pattern” setting is only available in [8.2 Burn-In (Auto Data)].
[Set Test Range]
100%
[Set Bad Limit]
0
