8
Total Control 2.0
HDA-8100
Owner’s Manual
8
Total Control
HDA-8100
Owner’s Manual
Network Setup
When using more than one (1) HDA devices, URC’s
HDA-SW5 Network Switch is
REQUIRED on the local network
.
For more information of the
HDA-SW5 Network Switch
, please refer to the
HDA-SW5 Owner’s Manual.
Although 3
rd
Party AVB switches may be utilized, they
are not supported
by
URC’s Technical Support team.
Connecting the HDA-8100 to the Network:
1. Connect an ethernet cable to an available
LAN port
on the head-end
network switch.
If no switch is connected to the network then connect the ethernet cable to
an available LAN port on the local router (Luxul preferred).
2. Connect the ethernet cable from the previous step to any available LAN port
on the
HDA-SW5
.
3. Connect another ethernet cable to an
available LAN port on the
HDA-SW5 Network Switch
.
4. Connect the ethernet cable from the previous step to the ethernet port
found at the
rear of the HDA-8100
(
).
5. Configure the HDA-8100 to a
DHCP/MAC reservation
within the local
router and program the device into the new or existing Total Control system.
A
certified URC integrator is REQUIRED
to integrate the
HDA-8100
into
a new or existing Total Control system.
1
2
HDA-8100
Local Router
HDA-SW5 Network Switch
