4
Upon unpacking
,
please check the contents against the packing list.
WARNING:
Before assembling the scooter, please make sure power switch is turned
'OFF'.
ESTIMATED TIME FOR ASSEMBLY
Assembly can typically be completed in 25 minutes
,
not including the time of
charging
for the first time.
Time of charging is 7 hours for the first time.
1.
Throttle knob
2.
Power switch
3.
Brake pedal
4.
Charging socket
Required Tools
Assembling the steering handle
WARNING:
The scooter must always be switched off while being charged.
1pc 12
—14mm open
spanner (Not provided
along with scooter)
1pc 13
—15mm open
spanner (Not provided
along with scooter)
2pcs 4mm hex keys
(Provided along with
the scooter)
1pc 4mm socket hexagon
spanner (Not provided
along with the scooter
1 pc screw driver (Not
provided along with the
scooter)
BEFORE YOUR START
ASSEMBLY
According to the figure 1, align the steering T-bar and push it onto the fork tube.
Ensure all four hales are aligned with each other. (The throttle knob on the handle
shall be on the right hand side when installed.)
insert a hexagon round flat head nut and bolt into the lock hole, as indicated in the
drawing, and tighten them using two 4mm hex keys
