P A M P O C K E T
P A M P O C K E T
P A M P O C K E T
P A M P O C K E T
ASSE M BLY AND M O UNTING INSTR UCTI O NS
M A - 8 0 2 8
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
STEP 1
STEP 1
STEP 1
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION
BOX FROM THE FUSE BOX/CIRCUIT BREAKER. TURNING
POWER OFF AT THE SWITCH IS NOT SUFFICIENT.
STEP 2
STEP 2
STEP 2
STEP 2
USING THE HEX WRENCH PROVIDED, LOOSEN THE SET
SCREWS AT THE BOTTOM OF THE FIXTURE ENOUGH TO
REMOVE THE MOUNTING PLATE FROM THE BACK OF THE
FIXTURE. SET THE FIXTURE AND SET SCREWS ASIDE.
STEP 3
STEP 3
STEP 3
STEP 3
LOCATE THE JUNCTION BOX AND PULL HOUSE SUPPLY CIRCUIT
WIRING THROUGH THE WIRE-WAY HOLE OF THE MOUNTING
PLATE. ATTACH THE MOUNTING PLATE DIRECTLY TO THE
JUNCTION BOX USING THE JUNCTION BOX SCREWS AND
DIRECTLY TO THE WALL SURFACE USING THE MOUNTING
SCREWS AND EXPANSION ANCHORS PROVIDED. IT IS IMPORTANT
TO CHECK LEVEL ON THE MOUNTED WALL PLATE.
STEP 4
STEP 4
STEP 4
STEP 4
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL
CONNECTIONS BY FOLLOWING THE ELECTRICAL CONFIGURATION
TABLE ON THE LAST PAGE. ENSURE THAT ALL ELECTRICAL
CONNECTIONS ARE WRAPPED WITH UL-LISTED ELECTRICAL
TAPE.
