Egg Box Placement & Roof Install
9
(2) 2x E1 Screws
Each Side
5 E3 Screws
(1)
Fit egg box assembly to back roost wall B2 and attach with 4 E1 screws through pre-drilled side holes in B2.
(2)
Slide egg box
roof panel C4 through slot in back side of B2 until notches in panel meet up with supports.
(3)
Using 2 E3 screws secure top of
roof in two positions.
(4)
Before screwing down bottom edge of roof, rack door end of eggbox left or right to make overhang on
each side of roof equal then drive 1 E1 screw up at an angle through top of leg that is near corner of eggbox, into eggbox door
frame, locking eggbox into place. Make sure egg box door swings down clear of leg post.
(5)
Finally, screw in bottom 3 E3 roof
screws, screwing down into C3 egg box door top rail.
B2
C4
© Urban Coop Company, all rights reserved.
Storage/Planter Area Fence
10
14
Set back storage area long piece D3 between legs A8 and egg box side fence board D2 and roost side board
D1 in place as shown. Drive one E1 brown screw from outside leg A8 through fence boards and into block
that is attached to D3. Repeat for other side. Drive a screw through the blocks on D1 & D2 into roost and
eggbox to hold sides in place. D1 and D2 are reversible so that they can be used regardless of how you orient
your roost box.
E1 Screw
E1 Screws
D3
A8
D1
D2
Optional
Waterer
Shown.
(5) E1 screw to lock
egg box in place.
C3
Roof panel
top edge with
E3 Screw.
Roof panel
bottom edge
with E3
screws
Skip this step if you ordered a planter box. See section
