Comfort mode
In this mode the system will run in constant Comfort
mode. To exit Comfort mode, use buttons
<
or
>
to
change operating mode.
When entering the Comfort mode menu, the
calculated supply temperature is shown and the supply
temperature offset starts flashing for about 7 seconds.
Changes to the offset can be made if initiated during
this time period.
0h
2
10
12
14
16
18
20
C
P
C
AUTO
22
24
4
6
8
When exiting the initial edit mode, by either waiting
for about 7 seconds or by pressing the
OK
button,
the controller shows the current supply and outdoor
temperatures. Use the
OK
button to toggle between the
edit and display modes.
0h
2
10
12
14
16
18
20
C
P
C
AUTO
22
24
4
6
8
Operation without a room thermostat
If the system is operating in heating mode without a
room thermostat, the circulation pump (P1) is running
continuously. If the system requires the pump to
switch off for a set number of minutes when the mixer
valve is closed, it can be set in
System parameters
>
Pump delay time
. The circulation pump then restarts
after each set interval to maintain the supply flow and
temperature. If the current temperatures fall below the
setpoints, the circulation pump will start again and run
continuously.
Change offset temperature when in another
operating mode:
1. Use buttons
<
or
>
to move the marker to the
Comfort mode symbol
. The calculated supply
temperature is shown and the supply temperature
offset starts flashing for about 7 seconds.
2. Use buttons
-
or
+
to change the offset
temperature.
Default: 0.0 ˚C
Setting range: -10.0 – 10 ˚C
3. Press the
OK
button or wait about 7 seconds until
the new setting is confirmed.
Current supply and outdoor temperatures, and the
forced operation symbol is displayed.
4. Use buttons
<
or
>
to get back to the previously
used operating mode.
Change offset temperature when in constant
Comfort mode:
1. Use buttons
-,
+
or
OK
to enter edit mode. The
calculated supply temperature is shown and the
supply temperature offset starts flashing for about
7 seconds.
2. Use buttons
-
or
+
to change the offset
temperature.
Default: 0.0 ˚C
Setting range: -10.0 – 10 ˚C
3. Press the
OK
button or wait about 7 seconds until
the new setting is confirmed.
Current supply and outdoor temperatures, and the
forced operation symbol is displayed.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
4 1
U P O N O R S M AT R I X M O V E / M O V E P L U S · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L