UPO PESUKARHU 6012, User Manual

Page: 65 / 72

297695
65
Failure Possible cause Remedy
FAILURE 7
Water is poorly pumped
out or not at all (machine
reports failure - the LEDs
periodically
fl ash seven
times).
Water outlet is clogged Check if:
• the
fi lter is clean,
• outlet pipe is not jammed,
• the drain is clogged,
• outlet pipe is positioned higher
than 1m.
Push START again
Laundry is not properly
spun.
No failure is reported. The machine switched on the
UKS* function. Because of bad
laundry balance, the machine
has automatically reduced spin
RPM. The machine operates normally.
Wash large and small pieces of
laundry together.
Greasy wads appear on
the laundry. Too little detergent (laundry was
very greasy). Wash the laundry again.
Add more detergent for such soiled
laundry, or use liquid detergent.
Laundry is stained after
washing. You used liquid detergent or
detergent for colored laundry
which does not contain whitener. Use the detergent containing
whitener.
White powdery residues
on the laundry. It is not the consequence of bad
rinsing, but because of neo-
phosphate detergents containing
non soluble components
(zeolites) for water softening.
Such substances may be
deposited upon the laundry. Immediately rinse the laundry once
again.
• Use liquid detergents which do not
contain zeolites.
• Try removing the residues with the
brush.
Detergent residues in the
dispenser. Low water fl ow pressure.
Some detergents may stick to
the dispenser rather hard if it is
wet.
• Clean the inlet pipe fi lter net.
• In case of low water pressure
increase water level.
• Wipe the dispenser prior loading
detergent.
Softener is not completely
rinsed, or water is left in
the dispenser dish. Sucking cover is not correctly
positioned or is clogged. Clean the dispenser and fi rmly fi x
the cover to its place.
Unpleasant smell in the
washing machine drum. • Remains of fabrics, washing
agent and softener in the fi lter.
• Development of germs
• Check whether the fi lter is clean.
• Run the Cotton 95°C program
without any laundry, using a powder
detergent.
Washing time is longer
than usual. • Low temperature of inlet water.
• Due to unevenly distributed
load, the machine has
activated the UKS*.
• Low mains voltage.
• There has been a failure in the
power supply.
• Washing program time may be up
to 60% longer; however, this does
not imply a fault in the machine.
• Washing time is extended by the
power supply down-time.