Upmost Technology netTV3 System, User Manual

Page: 9 / 38

9
6.
If you select PPPoE, you have to plug out the Ethernet cable from PC and reconnect it to the
ADSL Modem, then replug the T2
’ s power. Please notice the order of the two steps: Connect
Ethernet cable first, then plug on the power.
7.
T2 will reboot automatically for the network configuration to take effect. The NET indicator will
become green if you set successfully. And if the NET indicator is still red or off after 10 minutes,
please refer to the following instructions.
If the NET indicator is off or red, T2 can ’ t be
connected by internet. Please follow the steps below
for easy network troubles solution.
NET indicator is off:
1). Check if the two indicators of RJ-45 Ethernet
connector light green. If not please confirm that the
Ethernet cable and network device (modem or
router) are available.
2). If the connection type is PPPoE, please check if
the input account and password are correct. Then
check if the modem and telephone circuit are
available.
3). If the connection type is WiFi, you should confirm
that the wireless signal strength is at lease 3 bands
(full bands best). If not please decrease the distance
between T2 and wireless router.
And if the router is secured, please check if the input
key is correct. If the key is incorrect, you have to
reset T2 first.
NET indicator is red:
This status means that LAN connection is available,
but the connected router can
’ t forward ports which
T2 request to internet. Because T2 forwards ports by
UPnP as default, so you should check if the router
’ s
UPnP function is available.
Please connect PC and T2 to the same router, then
run net_Setup and select
“ UPnP Function Testing ” ,
and then click the “ Test ” button to start testing.
>> Test result: Doesn ’ t support UPnP
1). Enter into the router settings page and enable the
UPnP function (as right figure).
2). If the router doesn
’ t support UPnP, please use
DMZ or virtual server instead.