Uplus Lighting PIXEL IP20X15 BAR User Manual Download Page 3

 

 

1.Safety Instructions 

Please keep this User Guide for future consultation. If you sell the unit to another user, be sure 

that they also receive this instruction booklet. 

Unpack and check carefully there is no transportation damage before using the unit. 

•Before operating, ensure that the voltage and frequency of power supply match the power 

requirements of the unit. 

It’s important to ground the yellow/green conductor to earth in order to avoid electric shock. 

•The unit is for indoor use only. Use only in a dry location. 

•The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent 

surfaces. Be sure that no ventilation slots are blocked. 

•Disconnect main power before replacement or servicing. 

•Make sure there are no flammable materials close to the unit while operating as it is fire hazard. 

•Use safety cable when fixes this unit. DO NOT handle the unit by taking its head only, but always 

by taking its base. 

•Maximum ambient temperature is Ta: 40

. DO NOT operate it where the temperature is higher 

than this Unit surface temperature may reach up to 85

. DO NOT touch the housing bare-hand 

during its operation. Turn off the power and allow about 15 minutes for the unit to cool down before 

replacing or serving. 

•the event of serious operating problem, stop using the unit immediately.Never try to repair the unit 

by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please 

contact the nearest authorized technical assistance center. Always use the same type spare parts. 

•DO NOT touch any wire during operation as high voltage might be causing electric shock. 

Warning: 

•To prevent or reduce the risk of electrical shock or fire, do not expose the unit to

 

rain or moisture. 

•The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged. 

Caution: 

•There are no user serviceable parts inside the unit. DO NOT open the housing or attempt any 

repairs yourself. In the unlikely event your unit may require service, please contact your nearest 

dealer. 

Installation: 

Summary of Contents for PIXEL IP20X15 BAR













Reviews: