© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
4
Step 4
Take one of your Acoustic panels and a Panel plate and
line up the holes with the holes on the Post. Use the
provided Allen wrench to poke through the Acoustic
panel and Panel plate holes to help align them with
the holes on the Post.
Ensure the Panel plate is facing the correct way. The
side with the countersunk holes should be facing out,
so that the heads of the M5x25 Machine screws can fit.
Once lined up, insert a M5x25 Machine screw into each
hole and tighten by hand for a few turns until both
screws are started. Do not fully tighten the screws yet.
Step 5
Take another Panel plate and line up the holes on the
other end of the panel with the holes on the second Post.
Slide the Post assembly along the Rails to align the holes.
Once aligned, insert a M5x25 Machine screw into each
hole, and tighten by hand for a few turns until both
screws are started.
Once all four screws are started, you can tighten us-
ing your Allen wrench. Tighten until snug, but do not
over-tighten.
Step 6
Repeat steps 4 and 5 for the remaining Acoustic Pan-
els for this side of the frame.
top
