© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
10
Canopy
Parts Needed for One Canopy:
M5x25 Machine screw
(qty 8)
Allen wrench
(3mm)
Panel plate
(qty 2)
Canopy bracket
(qty 2)
Spacer
(optional. qty 1)
Acoustic panel
(qty 1)
The Canopy is designed for Cubicles only.
Attaching the Canopy to a Mobile Wall could present a tipping hazard.
Step 1
Make sure the Acoustic panel for the Canopy is the
same length as the Acoustic panels on the Cubicle
wall you are attaching the Canopy to.
If a post already has a Cubicle connector attached to
the top (L, S, T, or 4-Way), remove the two M5x25
screws opposite the side your Canopy will be locat-
ed on. Place a Canopy bracket over the Cubicle con-
nector bracket and replace the two removed screws
through both brackets and into the top of the Post.
If a Post does not have a Cubicle connector attached
to the top, place a Spacer on top of the Post and then
a Canopy bracket over the Spacer and install two
M5x25 screws through both pieces and into the top
of the Post.
Step 2
Then line up your Acoustic panel a Panel plate and
with the holes on the Canopy bracket. Use the provid-
ed Allen wrench to poke through the Acoustic panel
and Panel plate holes to help align them with the holes
on the Canopy bracket.
Ensure the Panel plate is facing the correct way. The
side with the countersunk holes should be facing to-
ward you, so that the heads of the M5x25 Machine
screws can fit.
Once lined up, insert a M5x25 Machine screw into each
hole and tighten by hand for a few turns until both
screws are started. Do not fully tighten the screws yet.
Repeat on the other side. Once all four screws are
started, you can tighten using your Allen wrench.
Tighten until snug, but do not over-tighten.
Adhesive strips
(optional. qty 2)
Panel cap
(qty 2)
