© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
4
C.
Take the two Side brackets (part 5) and attach them to the Leg
assemblies, using four (4) M6x14 Machine screws (part 12) each. Use
the Allen wrench, and
rotate each screw only a few turns.
Do not
tighten fully until step D.
If you are having trouble getting all the screws started, it is because
other screws are too tight. You’ll need to back out some screws in
order to loosen the tolerance of the screw holes.
D.
Once all of the parts are connected, you can now tighten the eight (8) Screws from Step B and the
eight (8) Screws from Step C (16 screws in total).
E.
Remove backing from the Adhesive pads (part 6) and position
along the assembly as shown. Be sure to not cover any of the holes.
F.
Slide Crossbar rails (part 4) back into Crossbar ends (part 3).
Ensure the slots of the Crossbar rails are facing inward. The slot on
the Crossbar rail is offset; it will need to be aligned in a specific way
to fit around the Machine screws. Make sure that the Crossbar rail
(part 4) can slide all the way to the end of the Crossbar end (part 3).
If it doesn’t fit, take the Crossbar rail out and flip it over, with the slots
facing inward and near the top of the edge, further from the floor.
3
3
3
4
12
5
6
G.
Attach each Foot (part 2) with four (4)
M6x14 Machine screws (part 12) and tighten
bolts in a cross pattern.
Be sure to point the long end of the Foot in
the same direction as the long end of the Side
bracket.
1
1
2
2
12
H.
Your desktop may be pre-drilled or include threaded inserts.
Please check both sides of the desktop for holes before placing
the table frame! If there are holes, carefully line up the frame to
match the holes on the underside of the desktop.
Adjust the width of the base to fit the desktop by sliding the two
halves outward. (33’’ max between the inside edge of Crossbar
ends)
If your desktop is not pre-drilled & does not include threaded in-
serts, place the base where you want it. We recommend leaving at
least 1/2” of desktop width on either side of the Side brackets.
The table feet are deeper than the Side brackets. If your top is
25.5”-27.5” deep and you want the rear edge of the top in line with
the rear edges of the feet, offset your desktop toward the back.
If you are using your own desktop,
please note that the Minimum desktop size is 43’’ wide x 24’’ deep.
The frame will not fit on any desktop smaller than this.
