Unverferth Rolling Harrow II, Operator'S Manual/Parts Catalog

Page: 37 / 66

ASSEMBLY
"A" DIM.
(FIG. 3-15D)
24"
36"
48"
ONE-BAR
SIZE
3'
4'
5'
TUBE
LENGTH
34"
46"
58"
46. Remove 7/16-14 U-bolt (95914) and 7/16-
14 locknut (9799) from the coil-tine drag
bar assembly. Position coil-tine drag bar
to the mounting arms. Reinsert U-bolt
(95914) around the tube and back through
the clamp (84720) and then through the
top two holes in the mounting arms, se-
cure with the 7/16-14 locknut (9799).
IMPORTANT: Refer to "Torque Chart" on page
21 when tightening all capscrews, carriage
bolts, and U-bolts on all drag bars.
COIL-TINE DRAG BAR
45. Refer to the table (below) for determining
one-bar length required, on each section.
FIG. 3-15D
OM-02286
OM-02372
FIG. 3-16
FIG. 3-17
OM-02373
TRANSPORT WHEELS USED WITH
COIL-TINE DRAG BARS
A. Remove one of the 5/16-18 x 1 3/4"
capscrews (9390-062) and locknut (9928)
that is directly behind the wing tansport
wheel as shown in Fig. 3-16.
B. Attach the clip (84837) bushing (84531),
capscrew (9390-062) and locknut (as
shown in Fig. 3-17).
IMPORTANT: The clip (84837) MUST be as-
sembled against the main tube of the drag bar
and around the inside of the Coil-Tine spring.
C. Once the capscrew is tight the coil-tines
should not hit the transpot wheels at any
time.