10
Parameter
Description and Configuration
Network Isolation
Keep the default value
Off
. It cannot be configured.
IP Address
Enter the IP address of the device.
The IP address of the device must be unique across the network and cannot begin
with 127.
Subnet Mask
Enter the subnet mask of the device.
Default Gateway
Enter the default gateway of the device.
When
Obtain IP Address
is set to
PPPoE
, complete the configuration by referring to the figure below.
If the device is connected to the network through Point to Point over Ethernet (PPPoE), you need to select PPPoE
as the IP obtainment mode. Then enter the username and password provided by your internet Service Provider
(ISP).
NOTE!
This function is not supported by some models. Please see the actual model for details.
When
Obtain IP Address
is set to
DHCP
, complete the configuration by referring to the figure below.
The Dynamic Host Configuration Protocol (DHCP) is enabled by default when the device is delivered. If a DHCP
server is deployed in the network, the device can automatically obtain an IP address from the DHCP server.
(3)
Configure IPv6 settings as shown in
2
in the figure above.
Parameter
Description and Configuration
IPv6 Mode
The default value is
Manual
. Keep the default value here.
IPv6 Address
Enter the IPv6 address of the device.
The IP address of the device must be unique across the network.
Prefix Length
Enter the length of the subnet prefix of the device.
Default Gateway
Enter the default gateway of the device.
(4)
Set parameters as shown in
3
in the figure above.
Parameter
Description and Configuration
MTU
The value ranges from 576 to 1500.
This parameter is not displayed when
Obtain IP Address
is set to
PPPoE
.
Port Type
The default value is
FE Port
. Keep the default value.
Operating Mode
The options are as follows:
