Unold 28605, Instructions For Use Manual

Page: 17 / 52

17
Before using the appliance the first time
1. Remove all packaging and any transportation
locks.
2. Check that all the listed accessories are
included.
3. Clean all parts with a damp cloth, as
described in the section “Cleaning the
appliance” (page 18).
4. Check that all the parts are correctly
assembled and that the appliance is in a
stable position.
5. Insert the plug of the power cord into an
electrical socket (230 V~, 50 Hz).
6. Open the lid of the appliance.
7. Fill the water tank with clear, cold water up
to the marker “12”.
8. Close the lid of the appliance.
9. Place the coffee jug with its lid closed onto
the hotplate.
10. Switch on the appliance by pressing the
“I/O” switch.
11. The red indicator lamp of the “I/O” switch
lights up and the brewing process begins.
12. Once the brewing process has finished,
switch off the appliance by pressing the
“I/O” switch once.
13. Discard the water from the first brew.
14. Clean the coffee jug and filter.
15. The appliance is now ready for operation
and you can start brewing coffee.
Before brewing coffee for the first time, please run one or two brewing cycles with water only to
remove any residue from the manufacturing process. We also recommend running one brewing cycle
without coffee if the appliance has not been in use for an extended period.
setting the time
Brewing coffee without the program function
1. Prepare the appliance, as described under
“Before using the appliance for the first
time” on page 17.
2. Open the lid of the appliance.
3. Fill the water tank with enough clear, cold
water for the required number of cups,
taking care not to exceed the maximum
capacity (marker “12”).
4. Make sure that the filter holder has been
correctly inserted into the appliance. The
filter holder can only be inserted in one
direction.
5. Fold over the bottom edge of the paper filter
and place it directly in the filter holder. The
paper filter must not protrude over the top of
the filter holder. If it does protrude over the
top of the filter holder, you will have to fold
it over several times until it fits.
6. Spoon the required amount of medium fine
ground coffee (5-7 g per cup according to
taste) into the paper filter. If the coffee
ground is too fine, it could clog up the pores
of the filter and cause the coffee maker to
overflow.
7. Close the lid of the appliance.
8. Place the coffee jug with its lid closed onto
the hotplate.
9. Press the “I/OF” switch.
10. The red indicator lamp of the “I/O” switch
lights up and the brewing process begins.
11. Once the brewing process has finished,
switch off the appliance by pressing the
1. As soon as the coffee maker is connected to
the mains supply, the time “0:00” will be
shown in the display.
2. To set the time, press the button marked
“H” (for the hours) and “M” (for the
minutes) as often is necessary for the
correct time to be displayed. The time is
shown in am/pm format, i.e. until 12 noon,
“am” is additionally shown in the display,
from 12 noon onwards, “pm”.
3. If neither button is pressed within
10 seconds, the appliance will return to
its original state. The current time will be
displayed and you can now start brewing
coffee.
4. The appliance does not save the time if
power is cut off for more than 10 seconds,
i.e. you will have to reset the time if the
appliance is disconnected from the mains
supply