7
Bass and treble:
You can adjust bass and treble if needed by using the two controls on the front panel.
Adjust the controls until desired sound balance is achieved.
Microphone sensitivity
If a microphone is connected to the loop driver the input level of the microphone might
need adjustment. This is done with the control located at the special microphone input
(Mic) on the rear panel. Proceed as follows: Turn on your TV at desired volume or speak into
the microphone. Adjust the control until the indicator to the left on the front panel lights up
in program peeks or when somebody speaks into the microphone. Now the correct level is
set.
Attention!
If no microphone is connected to the mic input the sensitivity control should be turned to
minimum (counter clockwise) to avoid poor sound intelligibility.
Listen to music with headphones
Univox® CLS-1 with its built-in automatic gain control (AGC) is developed for superior
speech intelligibility when used as a loop driver. However, while listening to music with
your hearing aid/s in T position, the sound might be unsatisfactory. This happens because
most hearing aids limit certain frequencies, for example bass tones, which might result in a
flat sound without nuances.
You can receive a richer more nuanced sound if you take off your hearing aid/s and instead
listen to the music with headphones connected to the headphones output on the rear
panel. The quality enhancement resulting from listening with headphones depends on the
type of hearing impairment you have and the type of headphones you use.
