5
loop should not be positioned at mid height as this will influence the performance of the
system. Connect the wire ends to the loop terminal on the rear panel. See the outputs on
the rear panel on the previous page.
Connect Univox® CLS-1 to your TV and/or other
sound source
Univox® CLS-1 has two inputs (3.5mm) that can be used to connect your TV, stereo or
other sound source and a special microphone input (3.5mm), which makes it possible to
pick up the sound from the speaker of the TV. The microphone input level can be adjusted
for this input.
See the inputs on the rear panel on the previous picture.
Start by checking your TV’s audio outputs and the outputs of the other input sources that
you want to connect. Consult the manual for each source for information on audio outputs
(RCA, Scart etc.)
Obtain the necessary cable/s for you Univox® CLS-1, if you have not already done so. You'll
find a list of cables and other related parts in section Accessories.
Connect your TV and/or other sound sources to the Univox® CLS-1 with the appropriate
cable according to the following guidelines:
TV/other sound sources
Connect TV, stereo etc. to the line input (Line). If you want to connect both TV and for
example a stereo, use the line input (Line) for one of the sound sources and the combined
mic/line input (Mic/Line) for the other sound source.
If you want to connect the audio output of your TV (RCA) to the driver, use an audio cable
with double RCA connectors at one end and a 3.5mm/
1
/
8
inch connector at the other end
(Audio cable, see section Accessories). To connect your stereo to the Univox® CLS-1 you
need the same cable.
