Recalling Pre-Programmed Settings
If you didn’t write down the code numbers you setup your Osiris with,
you can recall them via this simple process:
Enter SETUP mode by pressing and holding both MAIN and ENT
for three seconds.
Note:
You have 30 seconds for each step, otherwise the Osiris will time
out automatically.
Go to page two of the SETUP menu via the PAGE UP button.
Press the RECAL button. The display changes to the recall screens. The
screen automatically switches between four screens, alternately flash-
ing page one devices and code numbers then those for page two.
Note:
Pay attention to the page numbers on the bottom of the screen. Page
1 code numbers are the ones setup for the Page1 Devices. Page 2 code
numbers are the ones setup for the Page 2 Devices.
Write down the code numbers as they appear. Page 32 of this manual
gives a convenient list for you to note your settings.
Return to normal operation by pressing the MAIN button twice.
1
2
3
4
5
27
M X - 3 5 0
MX350 Manual.qxd 8/13/2004 10:04 AM Page 27
