Po
w
erBlaster
™
W
ARRANTY
10
Po
w
erBlaster
™
PROGRAMMING
9
STEP 6
Test Operation Without Flashers.
With the remote controls
line-of-sight output blocked by
your hand, a book or a pillow;
test the control of your
components using just the front
blaster. In most cabinets, the
PowerBlaster’s
™
front blaster will
control any A/V components in
the same cabinet space by
reflections from the cabinet
walls and doors. Make sure that
the components operate with the
cabinet doors closed or open.
If a component is placed too far
away from the front blaster, you
will need to utilize the included
flashers plugged into
PowerBlaster’s
™
rear flasher
jacks.
If you have problems with
components that are close to
the front blaster, try repositioning
PowerBlaster
™
farther away.
STEP 7:
Connect Flashers to Out-of-Sight
A/V Components.
Note:Test the operation
BEFORE sticking the flasher
in place.
Use a flashlight to identify the
correct location of the
component’s IR sensor, then try
a few commands while moving
the flasher around the face plate
of the component. The most
reliable operation typically
occurs a half inch or so away
from the IR sensor. Once you
have found the spot that gives
the most reliable operation, peel
off the protective backing of the
self-adhesive tape on the
included flashers and stick them
in place.
Note: Always replace the
self-adhesive tabs if you have
to reposition a flasher. Six
extra self-adhesive tabs are
supplied for this purpose.
Warranty
PowerBlaster
™
is covered against any manufacturers defects or
workmanship for a period of one year from the date of purchase if
purchased from an authorized Universal Remote Control dealer. Units
purchased from online auction sites or other unauthorized resellers
have no warranty. This warranty does not cover the following items:
- Damage from misuse, neglect, or acts of nature.
- Products that have been modified or incorporated into
other products.
- Products purchased more than 12 months ago.
- Units purchased from unauthorized dealers or companies.
Specifications
Power Supply: 9V 300mA
IR Flasher Line Outputs: 2.5mm Mono Mini Jack
RF Frequency: 418MHz
Who can I call for more answers?
The Universal Remote Control Technical Support and Customer
Service staff are ready to answer any questions you might have.
Call us at 1-914-835-4484
Monday - Friday, 9AM to 6PM (EST)
MRF100B Manual 1/2/06 1:39 PM Page 11
Summary of Contents for MRF100B POWERPACK
Page 7: ......
