1
U
S
I
N
G
C
C
P
E
D
I
T
O
R
T
O
P
R
O
G
R
A
M
The MX-iOS iPhone/iPad/iPod Touch remote can control up to 255 devices with up to 255 pages each.
Control these devices over the network via a base station, indoors and out, through walls and floors, and in
other rooms. Increase or decrease the living room television volume from your kitchen or other room
without pointing towards the TV. Before we can accomplish this, we need to program the MX-iOS in the
Complete Control Program.
This manual will guide you through the steps of programming your MX-iOS remote control, based on
the
Programming in CCP
manual found within CCP or in the URC Control Room. Each of the programming
steps below, are represented by symbols which compare that step with the programming process described
in the
Programming in CCP
manual. These symbols will help point out which steps are the same (green),
similar (yellow) or completely different (red) from the process described there. Make sure to review all of
the red (different) and yellow (similar) steps, because the programming procedure will be different. If you
would like further information regarding a specific step, refer to the
Programming in CCP
Manual.
Introduction
Different
STOP, you need to review this step.
When you see this symbol make sure to stop and read the
information provided. This step is totally different than described in the
Programming in CCP
manual.
Similar
Review this step as there are slight changes in the programming process. This step is similar to what is
described in the
Programming in CCP
manual.
Same
You may skip this step. It’s the same process shown in the
Programming in CCP
manual.
Complete Control Mobile Programming Manual for MX-iOS
