www.urcsupport.com
20
4.
Perform the instructions under
“Programming Device Control” on page 9 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
PROGRAMMING MACRO KEYS
The Potenza ST Universal Remote Control includes two
macro keys (located directly below the
MUTE
and
LAST
keys). Macro keys allow you to set up key macros to
activate certain keys in a specific order. For example, you
can set up a key macro to change the channels on your
TV, raise or lower the volume, and start recording on
your VCR, all with the touch of one key. If you want to
change the macros stored in a previously-programmed
macro key, you’ll need to clear the key first (see
“Clearing a Macro Key” on page 21).
Programming a Macro Key
3.
Select a macro key (for example,
F1
) and
press it once.
5.
On the remote control, press
STB
once; it will
blink once. Then press and hold
SETUP
until
the
STB
key blinks twice.
6.
Enter
9 8 2
. The
STB
key will blink twice,
indicating ID Lock is again locked.
1.
On the remote control, press and hold
SETUP
until it blinks twice.
2.
Enter
9 9 5
. The
SETUP
key blinks twice.
4.
Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press the
TV
mode
key once, followed by pressing the
VOL+
key
once.
Nebula Potenza ST.fm Page 20 Monday, October 15, 2007 4:55 PM
