9
2.5. Electrical connection
WARNING:
Your machine is set to
operate at 220-240V. If the mains voltage
supply to your machine is 110V, connect a
transformer of 110/220V and 3000W
between the electrical connections.
Connect the product to a
grounded outlet protected by a fuse
complying with the values in the
Technical Specifications "table".
The earthed plug of the
machine must be connected
to an earthed outlet supplied by
suitable voltage and current.
In the absence of earthing
installation, an authorized
electrician should carry out an earthing
installation. If operated without earthing
installed, Univa will not be responsible
for any loss of use that may occur.
The plug on this appliance may
incorporate a 13A fuse (country
specific)
2.6. Fitting the machine undercounter
If the machine is fit undercounter, sufficient
space is needed, and the wiring-plumbing
must be suitable to do so (
1
). If the space
under the countertop is suitable for fitting
the machine, remove the worktop as shown
in illustration (
2
).
WARNING:
The countertop, which
the machine will be placed under, must be
stable to prevent imbalance.
The top panel of the dishwasher must
be removed to fit the machine under the
countertop.
To remove the top panel, remove the
screws that hold it on, located at the rear
of the machine. Push the panel 1cm from
the front towards the rear and lift it.
Adjust the machine feet according to the
slope of the floor (
3
).
Fit the machine taking care not to crush or
bend the hoses (
4
).
WARNING:
After removing the
top panel of the dishwasher, the
machine should be placed in a
space of the dimensions shown
in the figure below.
H1: min A
H2: min B1
H3: min B2
A
B
All
Products
B
1
B
2
Product’s Height
(±2 mm)
820 mm
830 mm
835 mm
A:
If no felt on the top of the product; take into
account the product’s height.
B1
: If there is felt on top of the product
with 2nd basket; take the product’s height
into account.
B2
: If there is felt on top of the product
with 3rd basket; take the product’s height
into account.
.
